Displaying The Current Mfnm Mode Timeout Value; Setting The Current Mfnm Mode Timeout Value; Port Grouping Policy Considerations - HP StoreFabric SN6500B Administrator's Manual

3
Port Grouping policy

Displaying the current MFNM mode timeout value

1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the ag --pgfnmtov command to display the current MFNM timeout value.

Setting the current MFNM mode timeout value

1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the ag --pgfnmtov command, followed by a value in seconds.

Port Grouping policy considerations

Following are the considerations for the Port Grouping policy:
•
•
•
•
•
•
•
46
switch:admin> ag --pgfnmtov
Fabric Name Monitoring TOV: 120 seconds
switch:admin> ag --pgfnmtov 100
This sets the timeout value to 100 seconds.
A port cannot be a member of more than one port group.
The PG policy is enabled by default in Fabric OS v6.0 and later. A default port group "0" (PG0)
is created, which contains all ports on the AG.
APC policy and PG policy are mutually exclusive. You cannot enable these policies at the same
time.
If an N_Port is added to a port group or deleted from a port group and Automatic Login
Balancing mode is enabled or disabled for the port group, the N_Port maintains its original
failover or failback setting. If an N_Port is deleted from a port group, it automatically gets
added to port group 0.
When specifying a preferred secondary N_Port for a port group, the N_Port must be from the
same group. If you specify an N_Port as a preferred secondary N_Port and it already belongs to
another port group, the operation fails. Therefore, it is recommended to form groups before
defining the preferred secondary path.
If the PG policy is disabled while a switch in AG mode is online, all the defined port groups are
deleted, but the port mapping remains unchanged. Before disabling the PG policy, you should
save the configuration using the configUpload command in case you might need this
configuration again.
If N_Ports connected to unrelated fabrics are grouped together, N_Port failover within a port
group can cause the F_Ports to connect to a different fabric. The F_Ports may lose connectivity
to the targets to which they were connected before the failover, thus causing I/O disruption, as
shown in Figure 10 on page 42. Ensure that the port group mode is set to MFNM mode (refer
to "Enabling MFNM mode"
multiple fabrics and disables failover of the N-ports in the port group. For more information on
MFNM, refer to "Managed Fabric Name Monitoring mode"
on page 45). This monitors the port group to detect connection to
on page 44.
Access Gateway Administrator's Guide
53-1002743-01