HP StoreFabric SN6500B Administrator's Manual page 39

TABLE 7
Brocade
Model
6510
8000
Considerations for initiator and target ports
The following connections are possible for the Fibre Channel Protocol (FCP) initiator (host) and
target ports through AG:
•
•
•
For the last case, communication between initiator and target ports is not supported if both are
mapped to the same N_Port. Therefore, follow these recommendations for initiator and target port
mapping:
•
•
•
Brocade 8000 mapping differences
The Brocade 8000 contains 24 internal FCoE ports and 8 external Fibre Channel ports. In Access
Gateway mode, the internal FCoE ports are configured logically as F_Ports, while the external Fibre
Channel ports are configured as N_Ports. The FCoE ports are divided into six groups, or trunks,
consisting of four ports each. All four ports in a group are mapped to one N_Port. Although you can
change the default port mapping for these groups (refer to
consider the following when working with these FCoE ports:
•
•
•
•
Access Gateway Administrator's Guide
53-1002743-01
Access Gateway default port mapping (Continued)
Total ports F_Ports
48 0-39
32 8-31
FCoE ports
mapped as
F_Ports.
All F_Ports connect to all initiator ports.
All F_Ports connect to all target ports.
Some F_Ports connect to initiator ports and some F_Ports connect to target ports.
If connecting a host and target port to the same AG, you should map them to separate N_Ports
and connect those N_Ports to the same fabric.
Use separate port groups for initiator and target ports.
When configuring secondary port mapping for failover and failback situations, make sure that
initiator and target F_Ports will not fail over or fail back to the same N_Port.
All four FCoE ports in the group are mapped to the same N_Port.
You cannot map individual FCoE ports within the same port group to different N_Ports.
Any Access Gateway operation that involves moving F_Ports will move all FCoE ports in the
group.
All four FCoE ports in a group will fail over or fail back to one N_Port.
Access Gateway mapping
N_Ports Default port mapping
40-47 0-4 mapped to 40
5-9 mapped to 41
10-14 mapped to 42
15-19 mapped to 43
20-24 mapped to 44
25-29 mapped to 45
30-34 mapped to 46
35-39 mapped to 47
0-7 8-11 mapped to 0
12-15 mapped to 1
16-19 mapped to 2
20-23 mapped to 3
24-27 mapped to 4
28-31 mapped to 5
"Default port mapping"
2
on page 16),
19