Lexmark X746 User Manual page 257

Clearing jams
5
Firmly grasp the jammed paper on each side, and then gently pull it out.
Note: Make sure all paper fragments are removed.
6
Reinstall each photoconductor unit.
7
Close the front door, and then close the printer top access cover.
8
From the printer control panel, touch Continue, jam cleared.
Paper jam in the fuser area
1
Open the printer top access cover.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a hot
component, allow the surface to cool before touching it.
2
Open the front door.
Warning—Potential Damage: To avoid overexposing the photoconductor units, do not leave the front door
open for more than 10 minutes.
3
Determine where the jammed paper is located, and then remove it:
a
If the jammed paper is visible under the fuser, then firmly grasp the paper on each side, and then gently pull it
out.
Note: Make sure all paper fragments are removed.
b
If the jammed paper paper is visible at the top paper guide in the fuser assembly, then firmly grasp the paper
on each side, and then gently pull it out.
Note: Make sure all paper fragments are removed.
2
1
257