Frigidaire FPEF3081MF Use And Care Manual page 43

Problem Possible Causes
Oven portion of Incorrect oven control setting.
appliance does not
operate.
Lock feature may be active.
Entire appliance does Power supply to appliance
not operate. disconnected or electrical
power outage.
Service wiring is incomplete.
Range is not level. Floor is not level, weak or
unstable.
The cooktop or oven racks are
not level.
Cabinet alignment may make
range appear not level.
Cannot move
Carpet interferes with range.
appliance easily.
Cabinets are built in too tightly
Appliance must be
to appliance sides.
accessible for
service.
Convect fan makes The convect fan may turn ON
noise (some models). or OFF automatically.
Oven door is open.
Convect fan turns ON
and OFF while cooking
(some models).
Convect fan turns on For some models the convect
with features that fan may turn ON while
should run without a preheating.
fan (some models).
Oven control displays The probe is not fully inserted
"Prob ERR". The into the probe receptacle.
probe is not
If the error code persists, the
recognized by the
probe may be damaged or the
oven control (some
probe cable has a short.
models).
Solutions to common problems •
Solutions
Be sure the oven control was set correctly for the requested
feature. See Setting Oven Controls section and review
instructions for the desired cooking function in this manual or see
"Entire appliance does not operate" in this checklist.
Cancel the lock feature (some models).
Be sure appliance power cord is plugged properly to electrical
outlet. Check house circuit breaker; reset if needed. If the electric
service to the house is out, call your local electric utility for
service.
Contact your dealer, installing agent or authorized service agent
for assistance.
If floor under range is sagging or sloping, contact a carpenter to
correct the problem.
To correct, place oven rack in center of oven. Place a bubble (or
spirit) level centered on the oven rack. Adjust by turning leveling
legs at bottom of range until the oven rack rests level.
Be sure kitchen cabinets are square & have sufficient room for
appliance clearance.
Provide sufficient space so appliance may be lifted over carpet.
Contact builder or installer to make appliance accessible.
This is normal. On some cooking features the convect fan may run
until the feature is done or the door was opened or closed.
The convect fan will turn OFF if the oven door is opened while any
convect feature is active. Close oven door.
This is normal (some models).
Double check that the temp probe is fully inserted into probe
receptacle. Use only the probe originally supplied with range.
Remove the probe from receptacle and oven. The oven may still
be used normally without the probe. Call your authorized service
agent for a replacement probe.
BEFORE YOU CALL
43