Power Connector Cable - HP Compaq CQ58-200 Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
●
Memory module/wireless module compartment cover (see
●
Hard drive (see
●
Keyboard (see
●
Top cover (see
To remove the power connector cable:
1. Disconnect the power connector cable (1) from the system board.
2. Release the power connector cable from the clips (2) built into the base enclosure.
3. Remove the tape (3) that secures the power connector cable to the base enclosure.
Battery on page 34), and then remove the following components:
Hard drive on page 47)
Keyboard on page 53)
Top cover on page 57)
Spare part number
685085-001
WLAN module on page
Component replacement procedures
42)
69