HP Compaq CQ58-200 Maintenance And Service Manual page 79

●
USB board (see
●
Power connector cable (see
To remove the display assembly in its entirety:
1. Disconnect the display panel cable (1) from the system board.
2. Release the wireless antenna cables from the clips (2) built into the base enclosure.
NOTE:
CAUTION:
support the display assembly can result in damage to the display assembly and other
computer components.
3. Remove the five Phillips PM2.5×6.0 screws (1) that secure the display assembly to the
computer.
72 Chapter 4 Removal and replacement procedures
USB board on page
Models may have either one or two antennas installed.
Support the display assembly when removing the following screws. Failure to
67)
Power connector cable on page 69)