Table of Contents
Advertisement
_uJllg
•
Do not strike or shake the hard disk.
•
When the camera
is repaired
or inspected,
data may be erased, and the hard disk may be
formatted.
Back up all data before requesting
repair or inspection.
•
Play back your trial recording
to make sure the
video and audio have been recorded
properly.
•
When formatting
or erasing
data using the
camera,
only the file administration
information
is changed.
The data is not
completely
erased from the hard disk. If you
want to completely
erase all of the data, we
recommend
either using commercially
available
software
that is specially
designed
for that purpose,
or by physically
destroying
the camera with a hammer etc.
•
To prevent
damage
to the LCD monitor, DO
NOT
...push it strongly or apply any shocks.
...place the camera with LCD monitor on the
bottom.
•
To prolong
service
life
,..avoid rubbing it with coarse cloth.
•
The following
phenomena
for LCD monitor
use are not malfunctions.
._ While using the camera, the surface around the
LCD monitor may heat up.
._ If you leave power on for a long time, the surface
around the LCD monitor becomes hot.
•
For safety,
DO NOT
... open the camera's chassis.
... disassemble
or modify the unit.
... short-circuit
the terminals of the battery pack.
Keep it away from metallic objects when not in
use.
_. allow inflammables, water or metallic objects to
enter the unit.
-. remove the battery pack or disconnect the power
supply while the power is on.
-. leave the battery pack attached when the camera
is not in use.
-. place naked flame sources, such as lighted
candles, on the apparatus.
... expose the apparatus to dripping or splashing.
• Avoid using the unit
... in places subject to excessive humidity or dust.
... in places subject to soot or steam such as near a
cooking stove.
... in places subject to excessive shock or vibration.
_. near a television set.
... near appliances generating strong magnetic or
electric fields (speakers, broadcasting
antennas,
etc.).
... in places subject to extremely high (over 40°C or
104°F) or extremely low (under 0°C or 32°F)
temperatures.
•
DO NOT leave the unit
... in places of over 50°C (122°F).
... in places where humidity is extremely low (below
35%) or extremely high (above 80%).
... in direct sunlight.
-. in a closed car in summer.
_. near a heatel_
_. in high places such as on a TV. Leaving the unit in
high places while a cable is connected
may result
in a malfunction
if the cable is caught and the unit
falls onto the floor.
• To protect
the unit,
DO NOT
_. allow it to become wet.
... drop the unit or strike it against hard objects.
... subject it to shock or excessive vibration during
transportation.
... keep the lens directed at extremely bright objects
for long periods.
_. expose the lens to direct sunlight.
... swing it excessively when using the hand strap.
_. swing the soft camera case excessively when the
camera is inside it.
Advertisement
Table of Contents
