Table of Contents
Advertisement
Menus
Settings
([ ] = Factory-preset)_o
_
BASIC
SETTING
Press I_11 and then select
sub menus.
-
+_ PRESET
EXECUTE:
Performs
this function.
Returns
all the camera
settings
[CANCEL]:
Returns
to the menu screen
without
to their default
values,
executing
reset.
_o
DEMO MODE
OFF: Disables
the function.
Introduces
special
features
of
[ON]: Activates
the function.
the camera
at the following
NOTES:
cases.
• The demonstration
only works when the DC cord is
• When the menu screen is
connected,
not with the battery.
closed.
• If an SD card is in the camera, demonstration
will not
• When there is no operation for
take place even if this mode is set to [ON].
about 3 minutes after the power
switch is set to [_].
,a))) OPERATION
SOUND
Enables
you to set the operation
sound
or turn the operation
sound
on/off.
4_ REMOTE
Turns reception of the operation
signal from the remote control
on/off.
DROP DETECTION
Setting this function helps
prevent damage to the HDD by
enabling the camera to turn off
the power automatically when,
for example, it detects that it has
been dropped.
OFF: Turns off the operation
sound.
BEEP:
The beep sounds
when the power is turned
on
or off, and at the beginning
and end of recording.
-
[MELODY]:
Instead
of a beep, a melody
sounds
when
any operation
is performed.
OFF: The camera
does not receive the signal
from the
remote
control.
[ON]: Enables
operation
with the remote
control.
OFF: Disables the function.
[ON]: Activates the function.
To turn the unit on when the drop detection worked,
set the power switch to OFF, and to on again.
CAUTION:
Setting this function to off increases
the chances of
damaging the built-in hard disk if the camera is
accidentally
dropped.
Advertisement
Table of Contents
