Image 10.6 Owner's Manual page 21

e. Error code "E5" may appear in the PULSE display if a pulse error occurs. See HOW TO USE THE PULSE
SENSOR on pages 7 and 8, and HOW TO USE THE PULSE DISPLAY on page 11.
4. SYMPTOM: THE PULSE SENSOR DOES NOT FUNCTION PROPERLY
a. See HOW TO USE THE PULSE SENSOR on pages 7 and 8.
5. SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON
a. Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of f'wefeet or less in length.
b. If the walking belt still slows when walked on, please call our toll-free HELPUNE.
6. SYMPTOM: THE WALKING BELT IS OFF-CENTER WHEN WALKED ON
a. If the walking belt has shifted to the left, first remove the key and
UNPLUG THE POWER CORD. Using the belt tool, turn the rear
roller adjustment bolt clockwise 1/4 of a turn. Plug in the power
cord, insert the key and run the treadmill for a few minutes.
Repeat until the walking belt is centered.
q=
b. If the walking belt has shifted to the right, first remove the key
and UNPLUG THE POWER CORD. Using the belt tool, turn the
rear roller adjustment bolt counterclockwise 1/4 of a turn. Plug in
the power cord, insert the key and run the treadmill for a few
minutes. Repeat until the walking bolt is centered.
Belt Tool
STORAGE
Unplug the p_c_er cord when the treadmill is not in use.
Remove .the indicated I_oltand washer from the lower end of each
upright. Loosen the other bolt in each updghL CerefuUy lay the con-
sole on _e treadmill. Keep the bolts and washers in a secure loca-
tion.
It is recommended that the treadmill be covered during extended
periods of storage.