Connection Examples; Attaching The Casters - Ibanez IS412CA Owner's Manual

Connection examples

1. One speaker cabinet
This example shows an Ibanez TBX150H guitar amp head connected to a
IS412CS.Connect the output of the TBX150H to the MONO 4 Ω jack.
Since the TBX150H can produce 150W of output at 4 Ω, this system can
produce 150W of output.
2. Connecting two speaker cabinets in parallel
This example shows an Ibanez TBX150H guitar amp head connected to a
IS412CA and IS412CS. Set the STEREO/MONO switch to the MONO position,
and make connections as shown in the diagram.
Make connections as shown in the illustration.
In this case, the total impedance of the speaker system will be 8 Ω.
On each speaker cabinet, connect the cable to the 16 Ω jack.
When making connections to other amps, carefully read the owner's manual
for the device you are connecting, so that you can be sure to make connec-
tions correctly. In particular when connecting speakers to a tube amp, it is
extremely important to match the impedance of the amp and speaker system.

Attaching the casters

The included casters may be attached to this speaker cabinet.
The casters simply plug in; no tools are required.
The speaker cabinet is quite heavy. To avoid injury, this procedure should be
performed with care, by two or more people.
Procedure
1. Gently lay the cabinet on its back so that the grill faces
upward. Be careful not to pinch your fingers between
the back panel and the floor.
2. Insert the caster all the way into the hole as shown in
the illustration.
3. Attach the remaining three casters in the same way.
4. Finally, gently raise the cabinet upright. Using two
people, each person should grasp a handle on either
side and lift the cabinet together. Attempting to raise the
cabinet alone is extremely hazardous, since the casters
will roll. This step must be performed by two people.
In the case of defects
This product was carefully inspected before it left the factory. If you experi-
ence any problem during operation, please consult the dealer where you pur-
chased the product. So that servicing can be performed without unnecessary
delay, please describe the problem in detail.
Specifications and appearance of this product are subject to change without no-
tice for improvement.
11