Installation; Receiver Location; Optional External Equipment Connections; Ac Power Supply Cord - Panasonic CT-35S31S Operating Instructions Manual

Table of Contents

Advertisement

Installation
Receiver
Location
Locate for comfortable viewing. Avoid placing where sunlight or other bright light (including reflections) will fall on the screen. Adequate
ventilation is essential to prevent internal component failure. Keep away from areas of excessive heat or moisture. Do not position magnetic
equipment (motors, fans, other speakers, etc.) nearby.
Optional
External
Equipment
Connections
The Video/Audio connections between components can be made with shielded video and audio cables. For best performance, video cables
should utilize 75 ohm coaxial shielded wire. Cables are available from your dealer or electronic supply house. Before you purchase any
cables, be sure you know what type of output and input connectors your various components
require. Also determine the length of cable
you'll need.
"
AC Power Supply Cord
Insert (Polarized) plug into 120 volts 60Hz standard AC outlet. Do not defeat the safety purpose of the
A __,-.
polarized plug.
CAUTION: TO PREVENT ELECTRIC SHOCK DO NOT USE THIS (POLARIZED) PLUG WITH AN
EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADE CAN BE FULLY
INSERTED TO PREVENT BLADE EXPOSURE.
Polarized Plug
Remote Control
Battery Installation
& Replacement
Battery
Installation
Batteries: Use two "AA" batteries.
1. Turn the Transmitter face down. To remove bottom cover, press down on
marking and slide cover off in the direction indicated.
2. Install the batteries as shown in the battery compartment.
(Polarity (+) or (-)
must be correct.)
3. Replace the cover and slide in reverse until the lock snaps.
Precaution on Battery Use
Incorrect installation can cause battery leakage and corrosion that willdamage the
Remote Control Transmitter.
Observe the Following Precautions:
1. Batteries must be replaced as a pair.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (Example: "Zinc Carbon" with "Alkaline").
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used
batteries.
5. Battery replacement is necessary when Remote Control reacts sporadically or
stops operating the Receiver.
!/®
"'iiii""
Press Down Here And
Slide Cover Back
J
-6-

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ct-35s21s

Table of Contents