Table of Contents
Advertisement
INSTALLATION
Installation
Television
Location
This unit is intended
to be used
with an optional
stand
or entertainment
center.
Consult
your dealer
for available
options.
C3 Avoid excessive sunlight or bright lights, including reflections.
[D
Keep away from excessive
heat or moisture.
Inadequate
ventilation may cause internal
component
failure.
O
Fluorescent lighting may reduce remote control transmitting
range.
[D
Keep away from magnetic equipment, including motors, fans and external speakers.
Optional
Cable Connections
Shielded
audio
and video
cables
should
be used
between
components.
For best
results:
[]
Use 75-ohm coaxial shielded cables.
[]
Use appropriate
input and output connectors, that match your component connectors.
C]
Avoid long cables to minimize interference.
AC Power Supply
Cord
CAUTION: TO PREVENT ELECTRIC SHOCK MATCH WIDE BLADEOF PLUG TO
WIDE SLOT OF AC OUTLET AND FULLY INSERT. DO NOT USE A PLUG WITH A
RECEPTACLE OR OTHER OUTLET UNLESS THE BLADE CAN BE FULLY
INSERTED TO PREVENT BLADE EXPOSURE. FOR SOME MODELS THAT ARE
NON-POLAR[ZED, THE USE OF AN AC ADAPTOR CONNECTOR MAY
BE NECESSARY.
Cable / Antenna Connection
For proper reception, either a cable or antenna connection is required.
Cable Connection
Connect the cable supplied by your local cable company.
Note:
A cable converter box may be required
for proper reception.
Check
with
your
Ioca/
cab/e
company
for compatibility
requirements.
Antenna
Connections
£3
For proper reception of VHF/UHF
channels, an external antenna is
required. For best reception an outdoor antenna is recommended.
[]
Antenna Mode must be set to TV.
\l/
,
_--
Cable Preset
Cable Mode is preset at the factory, Antenna
users must change to Antenna Mode in the
Setup Menu.
Poladzed plug
Non*Polanzed
plug
Incoming
Cable from
Cable Company
75 Ohm VHFAJHF
on back of TV
Incoming
Cable from
Home Antenna
[]
Advertisement
Table of Contents
