A Disc For Recording - Sony Handycam DCR-DVD101E Operating Instructions Manual

Step 5 Preparing a disc for recording
5 Close the disc cover.
Your camcorder starts recognizing the inserted disc.
With a DVD-R, you can start recording immediately after [DISC ACCESS]
disappears on the LCD display.
The FORMAT display appears when you insert a DVD-RW. Proceed to step 6.
6
Use the inulti-selector to select [REC FORMAT].
7 Use the multi-selector to select desired recording format.
Your camcorder is set in VIDEO mode as the default setting. Refer to page 7
about recording mode.
8 Use the inulti-selector to select ]EXECUTE].
9 Use the nmlti-selector to select [YES].
The selection of the recording format is completed.
The disc formatting starts. When the formatting is completed, you can start
recording on the DVD-RW.
Notes
• It may take some time to recognize the disc depending on the disc type and condition.
• If you close the disc cover with the disc set incorrectly, it may cause your camcorder to
malfunction.
• You may hear the motor running when the disc cover is closed without a disc being
set. This is not a malfunction.
• Do not remove the battery pack or disconnect the AC adaptor while formatting.
• You can remove the disc when a power source is connected to your camcorder even
when vour camcorder is turned off. However, when you change the disc, the disc
recognition process does not start automatically.
To remove the disc
It may take some time to remove the disc depending on the disc condition or recorded
matrials.
Perform the step 3 on page 26.
Remove the disc.
Tips
• When you replace a disc, disc information such as the date you started to use it and
information on previously recorded areas appears for about 5 seconds. The
information on previously recorded areas may not be displayed correctly depending
on the condition of the disc.
• See page 129 for details on disc handling.
27