Table of Contents
Advertisement
INSTALLING THE FRONT RAIL
See Figures 15and 16.
•
Get the front rail pieces, the switch assembly, and
the following hardware:
6 square head bolts (5/16-18 x 1 in.)
6 flat washers (5/16 in.)
6 hex nuts (5/16-18)
2 screws (1/4-20 x 3/8 in.) (located on switch plate)
2 square nuts (1/4-20) (located on switch plate)
Front rail connector
Right and left end caps for front rail
2 screws (#8-32 x 112 in.)
•
Set aside end caps and screws until you have
alignedthe ripfence and front rail.
•
Insertthe s_ squarehead boltsintothe table and
extensions,so the boltheads extend outward112in.
•
Looselyattach a washer and a hex nut to each
bolt.
•
The back of the rail has two slots. Slide the upper
slot over the bolts. (Bottom slot is for switch.)
•
Align the dght rail from left to dght - Match the
7-1/8 in. mark on the right scale to the right
edge of the table saw base (main table). See
Figure 16.
•
Snug right rail against table. Finger-tighteneach
nut on the table and extensions.
•
Locate the switch assembly. The two screws are
installedthrough the back of the switch plate with
the square nuts extending out toward the front.
Note: The square nuts am loose on the switch plate.
•
Slide the square nuts into the lower slot of the rail.
•
Slide the switchassembly to a convenient position,
leaving ample clearance for the hendwheel.
Tighten securely with a screwdriver. Do not tighten
the rail bolts.
•
Attach the and caps and screws with a phillips
screwd dver.
WARNING:
Place the switch out of the
immediate work area to avoid accidentally
turning it off dudng operation.
SAWTABLE
TABLE
EXTENSION
SQUARE
HEADBOLTS
TABLE
EXTENSION
FRONT
CONNECTOR
FRONT RAIL
SCALE
RAILSLOT
FRONT RAIL
HEXNUT
FLAT
WASHER
Fig. 15
ENDCAP
SCREW
TABLE
EXTEI_ON
SWITCH SLOT
RIGHT SCALE
ERR FTSMRN"i'AB LESAW 315.22.8390
FRONTRAIL
WITHKEY
22
Fig. 16
Advertisement
Table of Contents
