Table of Contents
Advertisement
ALIGNING THERIPFENCE ANDFRONT RAIL
See Figures 17 and 18.
The ripfence scale indicatoris installedon the dght
side of the dp fence but can be removed and rein-
stalledon the left side if needed. If a cuttingoperation
requiresplacing the dp fence on the left side of the
blade, and you find relocating the scale indicator
necessary, simply unscrewand ra-attach it,
•
Hook the back of the rip fence over the rear rail.
Lowerthe front of the ripfence intothe groove on
the front rail.
• Slide the rip fence back and forth. It shouldmove
freely with about t/16 in. clearance between the rip
fence and table surface. If it doesn't, loosen the
nuts holdingthe front and rear rails and adjust it up
or down.
• When the fence ddas smoothly, tighten all rail
hex nuts with a 12 mm wrench.
•
Remove the rip fence and repeat the steps in the
two previous sections to install the remaining
sections of the front and rear rail assemblies.
•
Use the rail connectors provided to join each rail
assembly togather.
•
Slide the rip fence back and forth to make sure it
moves freely. Also check the clearance between
the rip fence and the table surface on the other
side of the blade.
HOOKOVER
REARRAIL
REARRAILHERE
TO INSTALL
SCALEINDICATOR
ONLEFTSIDE
RIPFENCE
Fig. 17
MOUN_NGTHE
MOTOR
See Figure 19.
•
Get the motorassembly, the motor mounting plate
and the following hardware:
4 hex bolts (5/16-18 x 1 in.)
8 fiat washers (5/16 in.)
4 lock washers (5/16 in.)
4 hex nuts (5/16-18)
2 hex bolts (5/16-t8 x3/4 in.)
Nota: Remaining hardware from this bag is used for
installing the belt guard.
•
Release the bevel lock handle (frontof cabinet)
and turn the bevel hendwheal (side of cabinet) until
the blade isfully vertical. Retightanthe bevel lock
handle.
• Align the holes in the motor mounting plate and the
motorbracket sothe top edges are even. Place a
fiat washer on the 1 in. belts and insertinto the
holes.
•
Installa flat washer, Iockwasher, and a hex nut on
each bolt. Hand tighten only. This is the motor
supportassembly.
•
Cantarthe motor side to side on the motor mount-
ing plate. Tighten the nuts with a 12 mm wrench.
•
Insertthe two rodson the motor supportassembly
into holes in the cradle. Push the motor in as far as
it will go. Thraad the two hex bolts intothe cradle
to clamp down on the rods. Do not securely
tighten bolts yet.
HE](BOLTS
RODS
RIPFENCE
MOTOR
MOTOR
BRACKET
ASSB_BLY
FRONT RAIL
WASHER
I in. HE]( BOLTS
Fig. 19
Fig. 18
23
CRRFT.t'N RR'I'ABLESAW 315.228390
Advertisement
Table of Contents
