Table of Contents
Advertisement
•
Raise the dp fence handle and remove the dp
fence,
•
Set the blade angle by looseningthe bevel lock
handle and turning the bevel handwheel. Retighten
the bevel lock handle.
•
Set miter gage to 0 ° if needed. Make sure miter
gage knobis securelytightened.
•
Place a supportthe same height as the top of the
saw table behind the sew for the cut work.
•
Make sure the wood is clear of the blade before
turning on the saw, Insert the key and lift the switch
to the ON position.Let the blade build up to full
speed before feeding the wood intothe blade with
the miter gage.
•
Hold the work firmly against the miter gage and
pushthe miter gage to feed the work intothe blade.
•
When the work is completed,press the switch off
and remove the key.
BEVELCROSS CUT
BEVEL LOCK
HANDLE
(NOT SHOWN)
Fig. 52
MAKING A BEVEL RIP CUT
See Figure 53.
Try out this cut on a piece of scrap wood before
cutting your workplace. Use a pushstickto move small
pieces of wood into and past the blade.
_k
WARNING:
Make sure the blade guard is
lowered over blade and is working properlyto
prevent possible injury.
• Set the blade angle by looseningthe bevel lock
handle and turning the bevel handwhael. Retightan
the bevel lock handle.
.1_ WARNING:
When makinga bevel tip cut, the
dp fence must be on the dght side of the blade.
OthenNisethe fence could trap the workpiece,
possibly causing kickbackand resultingin injury.
• Attach the dp fence on the right side of the bladeat
the correctdistancefrom the blade for the cut.
•
Place a supportthe same height as the top of the
sew table behindthe sew for the cut work.
,_, WARNING: Never stand directly in the lineof
cut, Stand to the side to reduce the chance of
injuryshould kickback occur.
•
Make sure the wood is clear of the blade before
turning ontha sew. Insert tha key and liftthe switch
to the ON position. Let the blade obtainfull speed
beforefeeding the workplace intothe blade.
•
Place the work firmlyagainstthe ripfence and feed
the work intothe blade.
_l,
WARNING: Never pusha small piece of wood
intothe blade with your hand. Use e bushstick as
the end oftha workpiece nears the blade.
• When the work iscompleted, press the switch off
and remove the key.
BLADE
ANGLED
SCALE
BEVEL_PC_
B_DE
Fig. 53
39
CRRFTSNIIN"TABLE9AW316.228,190
Advertisement
Table of Contents
