Table of Contents
Advertisement
INSTALLING THEBLADEGUARD
See Figures 23 - 25.
_L
WARNING:
If the blade is not fully lowered, turn
the height handwheelto lowerthe blade to prevent
injury.
•
Get the blade guard, the blade guard bracket,and
the followinghardware:
2 hex bolts(5/16-18 x 1/2 in.)
2 lock washers (5/16 in,)
3 socket head screws (1/4-20 x 3/8 in.)
3 fiat washers (1/4 in.)
• Align the lower end of the blade guard bracketand
the threaded boles of the cradle and insolt the hex
boltsand lock washers. Securely tighten with a 12
mm wrench.
•
Remove the throat plate, See page 34.
•
Put the blade guard assembly in place on the table
top, aligningthe screw holes in the riving knifeto
the holes in the bracket. Alignthe hole in the front
of the rivingknife base with the screw hole in the
cradle.
Note: The screw hole is located under the slot in
back of the throat plate.
•
Insert two socket head screws and two flat wash-
ere in the two holes at the back of the rivingknife
base, Securely tighten with a 5 mm hex key.
•
Insmt the third socket heed screw and fiat washer
into screw hole in cradle under throat plate,
Securely tighten with a 5 mm hex key.
•
Raise the blade all the way up.
SOCI_ET
HEADSCREWS
FLAT
WASHER
SOCKET
HEAD SCREW
FLAT
RIVING
KNIFE
BLADE
O
Fig. 24
BLADE
BLADE
GUARD
BRACKET
_NTI-KICKBACK
PAWLS
LOCK
WASHER
HEX
Fig. 25
Fig. 23
25
CRAFTSN R r'I'ABLE SAW 315,2283g0
Advertisement
Table of Contents
