Table of Contents
Advertisement
Adjusting the Computer Images (RGB menu only)
When displaying computer patterns which are very detailed (tiling, vertical stripes, etc.), interference
may occur between the LCD pixels, causing flickering, vertical stripes, or contrast irregularities in portions
of the screen. Should this occur, adjust "Clock", "Phase", "H-Pos" and "V-Pos" for the optimum computer
image. See page
44
Select the desired computer input mode with INPUT 1 or 2.
• Computer image adjustments can be made easily by pressing AUTO SYNC (
• To reset all adjustment items, select "Reset" on the "Fine Sync" menu screen and press ENTER.
Saving and Selecting Adjustment Settings
This projector allows you to store up to seven adjustment settings for use with various computers. Once
these settings are stored, they can be easily selected each time you connect a computer to the projector.
Saving the adjustment setting
• If a memory position has not been set, a resolution and frequency setting will not be displayed.
• When selecting the stored adjustment setting with "Select Setting", the computer system should match the stored setting.
49
for the procedure details.
Clock
Adjusts vertical noise.
Phase
Adjusts horizontal noise (similar to tracking on your VCR).
H-Pos
Centres the on-screen image by moving it to the left or
right.
V-Pos
Centres the on-screen image by moving it up or down.
). See page
Selecting a saved setting
for details.
51
Advertisement
Table of Contents
