I/P Conversion; Checking The Lamp Usage Time - Sharp NoteVision XG-NV7XE Operation Manual

I/P Conversion

Projector
2, 3, 4
(GUI) On-screen Display

Checking the Lamp Usage Time

Projector
(GUI) On-screen Display
39
Remote control
1, 6
5
Remote control
1
2
This function allows you to select either an interlaced
display or a progressive display of a video signal. The
progressive display projects a smoother video image.
(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)
1 Press MENU.
2 Press ß/© to select "Options".
3 Press ∂/ƒ to select "I/P Conversion", and then
press ©.
4 Press ∂/ƒ to select "Interlaced" or "Progressive".
5 Press ENTER to save the setting.
6 To exit from the GUI, press MENU.
Interlaced mode
Interlaced mode creates a single image through the activation
of scanning lines in two fields. Use this mode when projecting
moving images.
Progressive mode
Progressive mode creates a single image using all available
scanning lines, thereby eliminating the flicker and stripes that
result from interlaced source images projected as still images.
This function allows you to check the accumulated lamp
usage time.
(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)
1 Press MENU.
2 Press ß/© to select "Options". The lamp usage
time will be displayed.
• It is recommended that the lamp be replaced after
approximately 1,400 hours of usage. At this point, take the
projector to your nearest Sharp Authorised LCD Projector
Dealer or Service Centre to have the lamp replaced. See
page 47 for details.
MOUSE ADJ.
MOUSE ADJ.