Using The Adjustment Feet - Sharp NoteVision XG-NV7XE Operation Manual

Setting up the Screen

Using the Adjustment Feet

There are two front adjustment feet and a rear adjustment foot.
To lower the position of the picture, pull out the folded leg of the rear adjustment foot.
See the procedure shown below for using the front adjustment feet.
1
Press foot releases.
• The projector is adjustable up to approximately
3° from the standard position with the rear adjustment foot.
• When the height of the projector is adjusted, the image may become distorted (keystoned), depending on the relative
positions of the projector and the screen.
CAUTION
• Do not press the foot releases when the adjustment feet are extended without firmly holding the projector.
• Do not hold the lens when lifting or lowering the projector.
• When lowering the projector, be careful not to get your fingers caught in the area between the adjustment feet and the
projector.
Digital Keystone Correction
Projector
1, 5
2
3, 4
Pressing ∂ ∂ ∂ ∂ ∂
in Step 2
On-screen Display
3 3
3 3 Test Pattern 3
19
2
Adjust height of projector
and remove hands from foot
releases.
5° from the standard position with the front adjustment feet and approximately
Remote control
6
Pressing ƒ ƒ ƒ ƒ ƒ
in Step 2
4 4 4 4 4
g
3
Rotate feet to make minor
changes.
When the image is distorted due to the projection angle,
the Digital Keystone Correction function allows you to
correct it.
(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)
1 Press KEYSTONE.
2 Press ∂ to compress the upper part of the image.
Press ƒ to compress the lower part of the image.
3 Press ENTER to display a test pattern.
4 Press ENTER to clear the test pattern.
5 To exit, press KEYSTONE.
6 To reset, press UNDO.
• Straight lines or the edges of the displayed image may
become jagged.
MOUSE ADJ.