Recording From A Cd; Recording From The Radio - Sharp GX-CD5100W Operation Manual

Recording to a cassette tape (continued)
GX-CD5100W

■ Recording from a CD

1
Press the ON/STAND-BY button to turn the power on.
2
Load a cassette into the TAPE 2 cassette compartment with
side A facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the CD (CD) button and load the desired disc.
4
Press the button to choose
one side or both sides.
... To record on both sides.
... To record on only one side.
5
Press the button.
Recording will be paused.
6
Press the button to record on side A, or the
side B.
CD playback will start approximately 7 seconds after the tape
starts.
To perform programmed recording:
1 Programme discs and tracks. (See page 17.)
2 Press the (TAPE-2
3 Press the button to record on side A, or the
To stop recording:
Press the ( ) button.
The CD and tape will stop.
Note:
To record on both sides, begin with side A. (If recording is started
from side B, the tape will not switch over to side A.)
Caution:
Do not open the CD compartment during recording.
Auto restart function:
If the recording side is switched from side A to B during recording,
the system will record the interrupted track on side B from its begin-
ning. The recording will be made without cutting the beginning of the
track on side B.
22
button for
) button.
button for side B.

■ Recording from the radio

1
Tune in to the desired station. (See page 18.)
2
Load a cassette into the TAPE 2 cassette compartment
with the side A facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the button to choose one side or both sides.
... To record on both sides.
...To record on only one side.
4
Press the button.
Recording will be paused.
5
Press the button to record on side A, or the
the remote control for side B.
To record on both sides, begin with side A. (If recording is start-
ed from side B, the tape will not switch over to side A.)
To interrupt recording:
Press the button.
To resume recording, press the same recording button you pressed
in step 5. Other buttons do not allow resuming.
To stop recording:
Press the button.
Beat cancel switch:
If a whistling noise occurs when recording from an MW, SW1 or SW2
station, set the BEAT CANCEL switch to A, B or C, whichever gives
the best reception.
04/1/28 CX-GD5100V_EN2.fm
button on