Sharp GX-CD5100W Operation Manual page 25

9
Switch input with the or button, and then press the
MEMORY button.
To select the timer playback source: TUNER, TAPE 1, TAPE 2
or LINE IN.
To select the timer recording source: TUNER or LINE IN.
● When you select the tuner, select a station by pressing the
or button, and then press the MEMORY button.
● If a station has not been programmed, "NO P.SET" will be
displayed and timer setting will be cancelled.
10
Adjust the volume using the VOLUME control, and then
press the MEMORY button.
Do not turn the volume up too high.
11
Press the ON/STAND-BY button to enter the power stand-
by mode.
The "TIMER" indicator lights up and the unit is ready for timer
playback or timer recording.
12
When the preset time is reached, playback or recording
will start.
The volume will increase gradually until it reaches the preset
volume.
13
When the timer end time is reached, the system will enter
the power stand-by mode automatically.
Once timer:
The timer will be cancelled.
Daily timer:
The timer will operate at the same time every day. It will con-
tinue until the daily timer setting is cancelled. Cancel the daily
timer when it is not used.
Note:
When performing timer playback or recording using another unit con-
nected to the CD/LINE INPUT sockets, select "LINE IN" in step 9.
This unit will turn on or enter the power stand-by mode automati-
cally, however, the connected unit will not turn on or off.
Checking the timer setting in the timer stand-by mode:
1 Press the CLOCK/TIMER button.
2 Within 10 seconds, press the or
or "DAILY", and press the MEMORY button.
3 Within 10 seconds, press the or
CAL" or "DAILY CAL", and press the MEMORY button.
The unit returns to the timer stand-by mode after displaying the
settings in order.
Cancelling the timer setting in the timer stand-by mode:
1 Press the CLOCK/TIMER button.
2 Within 10 seconds, press the or
or "DAILY", and press the MEMORY button.
3 Within 10 seconds, press the or
OFF" or "DAILY OFF", and press the MEMORY button.
Timer will be cancelled (the setting will not be cancelled).
Reusing the memorised timer setting:
The timer setting will be memorised once it is entered. To reuse the
same setting, perform the following operations.
1 Turn the power on and press the CLOCK/TIMER button.
2 Within 10 seconds, press the or
or "DAILY", and press the MEMORY button.
3 Within 10 seconds, press the or
ON" or "DAILY ON", and press the MEMORY button.
4 Press the ON/STAND-BY button to enter the power stand-by
mode.
04/1/28 CX-GD5100V_EN2.fm
GX-CD5100W
button to select "ONCE"
button to select "ONCE
button to select "ONCE"
button to select "ONCE
button to select "ONCE"
button to select "ONCE
25