Setting The Clock (Remote Control Only) - Sharp GX-CD5100W Operation Manual

Setting the clock (Remote control only)

In this example, the clock is set for the 24-hour (0:00) display.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CLOCK/TIMER button.
3
Within 10 seconds, press the
"CLOCK", and press the MEMORY button.
4
Press the or button to select 24-hour or 12-hour
display and then press the MEMORY button.
"0:00" The 24-hour display will appear.
(0:00 - 23:59)
"AM 12:00" The 12-hour display will appear.
(AM 12:00 - PM 11:59)
"AM 0:00" The 12-hour display will appear.
(AM 0:00 - PM 11:59)
5
Press the
the MEMORY button.
Press the
Hold it down to advance continuously.
6
Press the
press the MEMORY button.
Press the
Hold it down to change the time in 5-minute intervals.
To confirm the time display:
[When the unit is in the stand-by mode]
Press the CLOCK/TIMER button.
The time display will appear for about 10 seconds.
or button to select
[When the power is on]
Press the CLOCK/TIMER button.
Within 10 seconds, press the
The time display will appear for about 10 seconds.
Note:
The "CLOCK" will appear or time will flash to confirm the time display
when the AC power supply is restored after a power failure or unplug-
ging the unit. If incorrect, readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from step 1. If the "CLOCK" is not appear
in step 3, step 4 (for selecting the 24-hour or 12-hour display) will be
skipped.
To change the 24-hour or 12-hour display:
1 Clear all the programmed contents. [Refer to "Clearing all the
memory (reset)" on page 29 for details.]
2 Perform "Setting the clock" from step 1.
04/1/28
or button to adjust the hour and then press
or button once to advance the time by 1 hour.
or button to adjust the minutes and then
or button once to advance the time by 1 minute.
or button to display the time.
GX-CD5100V_EN1.fm
GX-CD5100W
13