Recording From A Cd (Cds) - Sharp CD-BA2600H Operation Manual

Recording from a CD (CDs)

E-28 ENGLISH
Programmed Play (See page 15.)
You can record 3 CDs continuously.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a cassette into the TAPE 2 cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be performed.
3
Press the CD button and load the desired disc.
4
Press one of the 1 - 3 buttons on the remote control to select
the disc to be recorded first.
5
Press the REC PAUSE
button.
Recording will be paused.
6
Press the / (TAPE 2 ) button
to start recording.
z CD playback will start approximately 5 seconds after the tape starts.
z Recording is started from the selected CD. When the playback of the last disc
is finished or the end of the tape is reached, the CD and the cassette will stop
automatically.
To perform programmed recording:
1 Programme discs and tracks. (See page 15.)
2 Press the REC PAUSE ( ) button.
3 Press the / (TAPE 2 ) button.
To stop recording:
Press the (CD ) button.
The CD and tape will stop.
Note:
When the end of the tape is reached while recording, the CD player will display the
track number which was being played at that time, and stop automatically. If you want
to restart recording from the beginning of the interrupted track, turn over the tape,
press the REC PAUSE ( ) button and then the
tracks have been stored in memory by programming, recording will restart from the
first track stored in memory.)
( )
/ (TAPE 2 ) button. (If