Enhancing Your System; Troubleshooting Chart - Sharp DK-AP2 Operation Manual

Music system for ipod
Hide thumbs Also See for DK-AP2:
Table of Contents

Advertisement

Enhancing your system

DK-AP2
DK-AP2(BK)
The connection lead is not included. Purchase a commercially
available lead as shown below.
Portable audio
player
Computer
To the line output socket
Audio cable
(not supplied)
Listening to the playback sounds from portable
audio player, computer, etc.
1
Use Audio cable to connect the portable audio player,
computer etc. to the AUX IN socket.
When using video equipment, connect the audio output to this
unit and the video output to a television.
2
Press the ON/STAND-BY button to turn the power on.
3
Play the connected equipment.
If volume level of the connected device is too high, sound
distortion may occur. Should this happen, lower the volume of
the connected device.
Note:
To prevent noise interference, place the unit away from the
television.
12
A
U
X
N I
V
D I
E
O
O
U
T
D
C
N I
V 6
A
U
X
N I

Troubleshooting chart

Many potential problems can be resolved by the owner without
calling a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
General
Symptom
When a button is
pressed, the unit does
not respond.
No sound is heard.
Remote control
Symptom
The remote control does
not operate.
iPod
Symptom
No sound is produced.
No image appears on
the TV/monitor.
iPod will not charge.
Possible cause
Set the unit to the power stand-by
mode and then turn it back on.
Is the volume level set to "0"?
Possible cause
Is the AC power lead of the unit
plugged in?
Is the battery polarity correct?
Is the battery dead?
Is the distance or angle incorrect?
Does the remote control sensor
receive strong light?
Possible cause
The iPod is not playing.
The iPod is not properly connected
to the unit.
Is the AC power lead of the unit
plugged in?
The video cable is not properly
connected.
The TV/monitor's input selection is
not properly set.
The iPod is not making full contact
with the iPod connector.
The main unit is using batteries as
power supply.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dk-ap2bk

Table of Contents