Table of Contents
Advertisement
PRINTING
OUT REPORTS AND LISTS
NOTE
OK -
Transmission/reception was normal
P.FAIL- A
power failure occurred.
JAM -
A problem with the printing paper or document occurred.
BUSY -
The line was busy.
COM.E-O to COM.E-7 - A telephone line error prevented the transaction. Explanations
of the error numbers are given in the following tables, however, these are primarily for
use by service engineers. In general. you will want to simply try the transaction again. If
necessary, check with the other party to make sure their machine is functioning properly.
CANCEL - Transmission was cancelledbecausethe STOP
key was pressed, no
document was in the feeder, or the other machine requested transmission using a
function which your fax does not have.
CANCEL 3- Confidential t ransmission w as cancelledbecause
the receiving machine
does not have a confidential function. a confidential passcode is not programmed in it,
its memory is full, or it is not a Sharp model.
CANCEL 4- Confidential t ransmission was cancelled
because an incorrect mailbox
number was entered for a fax machine with confidential mailboxes.
CANCEL 5- A relayrequest
was not successful because the machine to which the
request was made has no relay function, it is not a Sharp model. or its memory was full.
CANCEL 6- A relayrequestwas notsuccessful b ecause
your machine's fax number
has not been entered into the relay machine's list of permitted numbers, an automatic
dialling number not stored in the relay machine was specified, or your fax number has
not been entered in your machine as described
in Chapter 2.
Transmission errors
E-() ~ .AA~r~orecognise handshake signal, but it has
I cannot recognise the handshake si9na~'rem
E-1
~
the
receiver
side.
E-2
Line disconnected during transmission.
1
E-3
Line disconnected after modem
speed fall-
1
back.
\
E-4
Line disconnected during multi-page
transmission.
I
E-6
Cannot recognize the handshake signal for
\
next page at receiver side.
E-7
No
response from receiver side or "disconnect
'
signal" is received at transmitter side.
Error was not corrected after the
E-8
predetermined number of retries because of
/
an error In a part of a page.
; Error occurred after or whiist reception by the
E-n I
remote (receiving) machine was revealed to be
; impossible.
I
E-12
Error occurred just after fall-back.
E-13 ~
Error occurred after a response to a
retransmission end command was received.
]
Reception errors
1
I
I
Able to recognise handshake signal, but it has
/
E-O ;
I
I
errors.
I
;
E-1
;
Line disconnected during reception.
I
~
E-2 ~
Cannot recognise the handshake signal from
the transmitter side.
,
~ E-s , Cannot recognise the last handshake signal
from the transmitter side.
)
i
Cannot recognise the handshake signal for
~
E-4
next page from the transmitter side in the
case of mode change.
I
I
E-5
Cannot recognise the handshake signal for
,
next page from transmitter side.
~
E-7
No
response from transmitter or "disconnect
signal" is received at receiver side.
E-8
Error occurred upon completion of reception
of all pages.
Error occurred when mode was changed or
!
E-9
transmission/reception switching was
I
performed.
~
,
:
E-10
Error occurred during partial page or physical
[
page reception.
Error owurred after or during inquiry from the
~ E-II
~ remote (transmitting) machine as to whether
i
reception was possible or not.
~
E-12
Error occurred during or just after fallback.
;
E-13
Error occurred after retransmission end
command was received.
~
E-I4
Error occurred after voice communication
, command was received.
)
8-2
PRINTING OUT REPORTS AND LISTS
Advertisement
Table of Contents
