Table of Contents
Advertisement
.
LOADINGPRINTINGPAPER
The paper tray holds the paper on which received documents and copies are printed.
Up to 100 sheets of
A4 size paper from 60 to 90
glm2 can be loaded in the tray.
Comments:
Plain paper has a 'print" side which should be used to obtain the bestprint quality. me print
side is not visible to the naked eye, so check the label on the end of the package before
removing the paper. The print side will be indicated by an arrow,, symbol, or wording. Load
the paper in the tray print side up as described below.
Best printing results can be obtained from using clean, unused paper. We do not recommend
that you use paper that has already been printed on one side, as print quality problems or
paper jams may result. Some photocopier machines use toner that fuses at a lower
temperature than that used in your printer. If you run these through the printer, the toner
which is already on the paper may fuse onto the roller in the fusing unit.
Some pre-printed sheets also use inks or coatings that maybe atiected by the heat from the
fusing unit. If possible, check with the suppiierbefore using such papers. Moreover, print
quality cannot be guaranteed for paper with a particularly rough texture or embossing.
1
Remove the paper tray cover.
2
Fan the paper, and then tap the edge
against a flat surface to even the
stack.
3
Pull the lever on the right side of the
paper tray (marked "PULL") toward
you.
A i!
INSTALLATION
1-11
Advertisement
Table of Contents
