Assembly And Connections - Sharp F-2700M Operation Manual

.
ASSEMBLY AND CONNECTIONS
Comments:
Your fax is set for tone diailing. If you are on
a pulse only dial line, you must reset it
for pulse
dialling by changing Option Setting 16. This
procedure is describedin Chapter 7,
"Optional
Settings".
if you intend to use a computer fax modem on the same phone line, you must reset Option
Setting 10 to OFFin order to prevent transmission and reception errors. This procedure is
describedin Chapter 7, "Optional Settings
If your area experiences a high incidence of lightning or power surges, we recommend that
you install surge protectors for the power and telephone lines. Surge protectors can be
purchased from your dealer or at most telephone specialty stores.
WARNING NOTICE: For all units installed in New Zealand, only the T setting for tone dialling is
permitted. The P setting for pulse dialling does not operate properly and must not be used.
Moving your fax and reconnecting
Should it be necessary to move your fax to a new location, first disconnect the
telephone line cord before disconnecting the power lead. When reconnecting, it is
necessary to connect the power lead before connecting the telephone line cord.
Adjust the volume of the speaker for on-hook dialling as follows:
1
SPEAKER
FUNCTION
Press the FUNCTION key and then the
(
o
SPEAKER key.
2
m
or
o *
Press the "#" key to turn the volume
up, or the "*" key to turn it down.
3 START
o
0 I
Press the START key.
To adjust the volume of the ringer, reset Option Setting 19 as described in Chapter 7,
"Optional Settings". (Note that the volume of the handset receiver is adjusted
automatically.)
INSTALMTlON
1-7