Rack Stabilizer Feet; Recommended Tools And Supplies; Rack Kit Contents - Dell PowerEdge R805 Installation Manual

Rack Stabilizer Feet

CAUTION:
Before installing systems in a rack, install front and side stabilizers on
stand-alone racks or the front stabilizer on racks joined to other racks. Failure to
install stabilizers accordingly before installing systems in a rack could cause the
rack to tip over, potentially resulting in bodily injury under certain circumstances.
Therefore, always install the stabilizer(s) before installing components in the rack.
The stabilizer feet help prevent the rack from tipping over. See the
documentation provided with the rack cabinet for instructions on installing
and anchoring the stabilizer feet.

Recommended Tools and Supplies

You may need the following items to install the system in a four-post rack
cabinet:
• #2 Phillips screwdriver
• Masking tape or a felt-tip pen, for use in marking the mounting holes
to be used

Rack Kit Contents

• One pair of slide assemblies
• One cable-management arm (optional)
• One left cable-management arm ramp assembly
• One right cable-management arm ramp assembly
• One status indicator cable (if applicable)
• Eight 10-32 x 0.5-inch flange-head Phillips screws
NOTE:
The nonmetric screws described in illustrations and in procedural steps are
identified by size and number of threads per inch. For example, a #10 Phillips-head
screw with 32 threads per inch is identified as a 10-32 screw.
NOTE:
Both the right and left cable-management arm ramp assemblies are
illustrated in Figure 1-1. Depending on the orientation of the cable-management arm
(CMA), you will only use one ramp assembly to secure the CMA to the back of the
rack. For more information, see "Attaching the Cable-Management Arm Ramp
Assembly" on page 22.
8
Rack Installation Guide