Installing The Versarails Mounting Rails - Dell PowerEdge R805 Installation Manual

2 Push the mounting rail forward until the mounting hooks enter their
square holes, and then push down on the mounting-bracket flange until
the mounting hooks seat and the push button pops out and clicks
(see Figure 1-5).
3 At the back of the cabinet, pull back on the mounting-bracket flange until
the mounting hooks enter their square holes, and then push down on the
flange until the mounting hooks seat and the push button pops out and
clicks.
4 Repeat step 1 through step 3 for the mounting rail on the other side of
the rack.
NOTE:
position on both sides of the rack.

Installing the VersaRails Mounting Rails

NOTE:
Ensure that the rotating mounting brackets on the slide assemblies are
in the VersaRail configuration. See Figure 1-6.
1 At the front of the rack cabinet, position one of the mounting rails
so that its mounting-bracket flange fits between the marks you placed
(or numbered locations) on the vertical rails in "Marking the Rack"
on page 10 (see Figure 1-6).
The three holes on the front of the mounting-bracket flange should align
with the holes between the marks you made on the front vertical rail.
2 Install two 10-32 x 0.5-inch flange-head Phillips screws in the upper and
lower holes in the mounting-bracket flange to secure the mounting rail
to the front vertical rail.
3 At the back of the cabinet, pull back on the mounting-bracket flange until
the mounting holes align with their respective holes on the back vertical
rail.
4 Install two 10-32 x 0.5-inch flange-head Phillips screws in the upper and
lower holes in the mounting-bracket flange to secure the mounting rail
to the back vertical rail.
5 Repeat step 1 through step 4 for the mounting rail on the other side
of the rack.
NOTE:
on the vertical rails on each side of the rack.
Ensure that the mounting rails are mounted at the same vertical
Ensure that the mounting rails are mounted at the same position
Rack Installation Guide
15