Installing The System In The Rack - Dell PowerEdge R805 Installation Manual

Installing the System in the Rack

CAUTION:
If you are installing more than one system, install the first system
in the lowest available position in the rack.
CAUTION:
Because of the size and weight of the system, never attempt to install
the system in the mounting rails by yourself.
1 Pull the two inner slide rails out of the rack until they lock in the fully
extended position.
2 Lift the system into position above the extended slides.
The three shoulder screws on the sides of the system fit into the
corresponding J-slots (see detail on Figure 1-7) on the inner slide
assemblies.
3 Lower the back of the system while aligning the back shoulder screws
on the sides of the system with the back J-slots on the slide assemblies.
4 Engage the back shoulder screws into their respective J-slots.
5 Lower the front of the system and fit the middle and front shoulder screws
into the J-slots in the slide assemblies.
The system release latch at the front of the inner slide rail will snap back as
the shoulder screw passes into the front slot. Use this system release latch
when you wish to remove the system from the slide assemblies.
6 Press the slide-release latch on the outside of each inner slide, then push
the system into the rack.
7 Install the cable-management arm. See "Installing the Cable-Management
Arm" on page 19.
8 Tighten the thumbscrews on the rack front panel to secure the slide
assemblies to the rack.
Rack Installation Guide
17