Installing The Rack Stabilizer Feet - Dell PowerEdge 2410 Installation Manual

Installing the Rack Stabilizer Feet

CAUTION:
Installing systems in a rack without the front and side stabilizer feet
installed could cause the rack to tip over, potentially resulting in bodily injury
under certain circumstances. Therefore, always install the stabilizer feet before
installing components in the rack.
Install stabilizer feet on the rack as follows:
• Install front and side stabilizer feet on a standalone rack.
• Install front stabilizer feet on all racks in a suite, and install a left or right
stabilizer foot on the racks at each end of a suite.
To install a front stabilizer foot, perform the following steps:
1 Open the front door.
2 Reach into the rack and pull up firmly on the stabilizer to detach it from
the frame.
3 Position the front stabilizer foot against the base of the rack frame and
align its holes with the corresponding holes in the frame.
4 Use a 5-mm Allen wrench and the provided Allen bolts to secure the front
stabilizer foot to the rack as shown in Figure 1-9.
Dell™ PowerEdge™ 4210 Installation Guide
21