Power Block - HP StorageWorks 9100 - Extreme Data Storage System Maintenance And Service Manual

Release the cable management arm and expand to the rear of the chassis.
5.
Push the drawer in another 25 cm (10 in).
6.
Install the power block
7.
WARNING:
drive drawers.
Install the hard drives.
8.
Close the drawer.
9.
Install all rear panel components.
10.
Connect the cables.
11.

Power block

To remove the component:
Power down the MDS600
1.
Disconnect all cables.
2.
Remove all power supplies
3.
Remove the fans ("Fan" on page 29).
4.
Remove the I/O modules
5.
Disengage the cable management arm lock from each hard drive drawer:
6.
Pull the mechanism up, and then toward the rear of the chassis to disengage it from the locking
a.
plate.
("Power block" on page 35).
Pinch hazard—Keep hands out of front and rear of chassis when closing hard
("Power down" on page 24).
("Power supply" on page 30).
("Hot-plug I/O module" on page 30).
Removal and replacement procedures 35