Extend The Hard Drive Drawer; Hard Drive Blank - HP StorageWorks 9100 - Extreme Data Storage System Maintenance And Service Manual

Power down the partner server blades. See the server blade documentation.
1.
Press and hold the Power On/Standby button for approximately 4 seconds. This action powers
2.
down both hard drive drawers.

Extend the hard drive drawer

Be sure the I/O modules are fully seated and their handles are in the locked position.
1.
WARNING:
do not extend the hard drive drawers beyond the supporting surface when the unit is not
installed in a rack.
WARNING:
one hard drive drawer is extended at a time.
WARNING:
adequately support the chassis during installation and removal. It is not secured to the rack
frame or mounted on rails.
Extend the hard drive drawer.
2.
WARNING:
drive drawers.

Hard drive blank

CAUTION:
unless all bays are populated with either a component or a blank.
To remove the component:
Extend the hard drive drawer (on page 25).
1.
TIP HAZARD! To reduce the risk of personal injury or damage to the equipment,
To reduce the risk of personal injury or damage to the equipment, ensure that only
To reduce the risk of personal injury or damage to the equipment, you must
Pinch hazard—Keep hands out of front and rear of chassis when closing hard
To prevent improper cooling and thermal damage, do not operate the MDS600
Removal and replacement procedures 25