Hard Drive Drawer - HP StorageWorks 9100 - Extreme Data Storage System Maintenance And Service Manual

Remove the component as indicated.
3.
To replace the component, reverse the removal procedure.

Hard drive drawer

To remove the component:
Power down the MDS600
1.
Disconnect all cables.
2.
Remove all power supplies
3.
Remove the fans ("Fan" on page 29).
4.
Remove all hard drives
5.
Be sure the hard drive drawer is closed all the way.
6.
Remove the I/O modules
7.
Pull down the handle on the front of the drawer but do not extend the drawer.
8.
("Power down" on page 24).
("Power supply" on page 30).
("Hard drive" on page 26).
("Hot-plug I/O module" on page 30).
Removal and replacement procedures 31