Remove the component as indicated.
2.
To replace the component, reverse the removal procedure.
Power block
To remove the component:
Power down the D6000
1.
Disconnect all cables.
2.
Remove all power supplies
3.
Remove all fan modules ("Fan" on page 24).
4.
Remove all I/O modules
5.
Release the hard drive drawers:
6.
Pull down the handle on the front of the drawer, but do not extend the drawer.
a.
("Power
down" on page 21).
("Power
supply" on page 27).
("Hot-plug I/O
module" on page 25).
Removal and replacement procedures 28