Cable Management Arm - HP StorageWorks 9100 - Extreme Data Storage System Maintenance And Service Manual

Remove the power button/UID board.
9.
To replace the component, reverse the removal procedure.

Cable management arm

To remove the component:
Power down the MDS600
1.
Disconnect all cables.
2.
Remove all power supplies
3.
Remove the fans ("Fan" on page 29).
4.
Remove all hard drives
5.
Be sure the hard drive drawer is closed all the way.
6.
Remove the I/O modules
7.
Remove the power block
8.
Remove the hard drive drawer
9.
Remove the T-15 Torx screw that secures the cables to the hard drive drawer, and then remove the
10.
cables.
("Power down" on page 24).
("Power supply" on page 30).
("Hard drive" on page 26).
("Hot-plug I/O module" on page 30).
("Power block" on page 35).
("Hard drive drawer" on page 31).
Removal and replacement procedures 41