Table of Contents
Advertisement
caution
Do not touch the glass
portion of the lamp assembly.
Touching the glass could
result in premature lamp
failure.
note
Be sure to seat the lamp fully
and secure the lamp cover. If
the lamp is not properly
installed or the cover is loose,
the lamp will not turn on.
note
Do not reset the lamp timer if
you have not replaced the
lamp. If you do, the Lamp
Hours will not accurately
reflect the number of hours
that the lamp has been used.
Maintenance and Transportation
78
7. Gently insert the new lamp along the guide rail. If it doesn't fit
easily, make sure it's facing the correct way. Push the lamp down
firmly where the label
8. Once the lamp is fully inserted, tighten its screws.
9. Lower the lamp cover into place. (The opening should be almost
covered, and the top of the cover should be flush with the top of
the projector.) Then slide the cover closed and tighten the screw.
10. Reset the lamp timer as described in the next section.
Resetting the Lamp Timer
You must reset the lamp timer after replacing the lamp to clear the
warning message. Follow these steps:
Replace the Lamp
1. Connect the power cable and turn on the projector.
2. Press the
button on the remote control or projector and
Menu
select the
menu. Then press
Reset
appears.
PUSH
. You see the following:
Enter
Advertisement
Table of Contents
