Epson PowerLite S5 Series/77c User Manual page 89

If you're projecting from a composite or S-Video source, check
■
the
Video Signal
it set at . If you're using a 60-Hz PAL video source, change
Auto
this setting to
PAL60
Make sure the cables are securely connected at both ends.
■
■ Select the correct resolution; see "Compatible Video Formats" on
page 98.
■ If you're projecting from a computer, press the
the remote control or the
tracking and sync automatically. If that doesn't work, try
adjusting the
Sync
See page 59.
The image is blurry.
■ Adjust the focus using the focus ring.
There may be dirt or smears on the lens. Clean the lens as
■
described on page 74.
Make sure the lens is not fogged by condensation. You may need
■
to wait before using the projector after moving it from a cold
environment.
■ Make sure the projection distance is within the range described on
page 16.
Adjust the
■ Sharpness
You should be able to see the effect on the screen immediately.
You see vertical stripes or the image still looks blurry after
trying the solutions in the previous section.
■ If you're projecting from a computer and displaying an image that
contains a lot of fine detail, you may notice one or more vertical
stripes or bands, or some of the characters may look heavy or
blurred. Press the
Auto
the projector's tracking and sync settings.
setting in the Signal menu. In most cases, leave
. See page 60 for details.
button on the projector to adjust
Enter
and settings in the Signal menu.
Tracking
setting on the Image menu (see page 57).
button on the remote control. This resets
button on
Auto
Solving Problems
89