Resetting The Lamp Timer - Epson EMP-3300 Owner's Manual

7. Gently insert the new lamp by lowering it into position.
8. Tighten the screws you loosened in step 5.
9. Replace the lamp cover and tighten the cover screws.

Resetting the lamp timer

After changing the lamp, you need to reset the lamp timer as follows:
1. Make sure the projector is turned off.
2. Hold down the Menu and Sync buttons on the projector simultaneously and
The three monitor lights start flashing, indicating that the lamp timer has been
reset.
Make sure the lamp cover is securely fastened. The projector turns itself off
if the lamp cover is open.
turn on the projector, while continuing to hold down the Menu and Sync
buttons for several seconds after the power comes on.
Replacing the Lamp
61