On-Screen Error Messages - Sharp DV-HR400S Operation Manual

On-screen Error Messages

Messages Relating to DVD and HDD
• The following messages appear on the TV screen in case the disc you tried to playback is not appropriate or
the operation is not correct.
Error message
CANNOT PLAY THIS DISC.
INCOMPATIBLE DISC.
CANNOT OPERATE.
DISC IS PROTECTED.
COULD NOT REPAIR THE DISC.
COULD NOT FINALISE.
RECORDING PROHIBITED.
CANNOT RECORD.
TITLE (CHAPTER) IS FULL.
CANNOT RECORD ANY MORE.
CANNOT RECORD ON THIS DISC.
NO CASSETTE IN CAMCORDER.
(DV-HR480S/DV-HR450S only)
COULD NOT INITIALISE.
DISC IS FULL.
CANNOT RECORD.
CANNOT RECORD THIS PROGRAM ON
THIS DISC.
CANNOT DETECT CAMCORDER.
(DV-HR480S/DV-HR450S only)
SET THE DATE AND TIME.
HDD IS FULL, STOPPED RECORD-
ING.
REPAIRING THE DISC.
Possible Error
• The disc cannot be played back with
this Recorder.
• If you load a disc which cannot be
played with this Recorder (i.e. a
scratched disc), or if you load a disc
upside down, this message will
appear, and the disc tray will
automatically pop out.
• Occurs if operation is incorrect.
• Occurs if you attempt to record or edit
a disc for which disc protection is set.
• If there is a power failure during DVD
recording, the system automatically
tries to recover data after power is
restored. This error occurs if such
recovery is impossible as the disc is
scratched or dirty.
• Occurs if the disc is scratched or
dirty, etc.
• Occurs if video with a copy guard
signal is input.
• Occurs if a title or chapter marker
exceeds the recordable upper limit.
• Number of titles: HDD 199/DVD 99.
Number of chapters: HDD 999/
DVD 999
• Occurs if you load a disc which cannot
be recorded to with this Recorder, or a
disc which is scratched or dirty.
• Occurs if you attempt operation when a
tape has not been loaded in the digital
camcorder linked via DV connection.
• Occurs if the disc is scratched or
dirty, etc.
• Occurs if there is no empty space in
the disc.
• Occurs if you try to record a "Copy
Once" broadcast onto a disc which is
not compatible with CPRM.
• Occurs if you set to DV input without
connecting a digital camcorder.
• Occurs if multiple digital camcorders
are connected.
• Occurs if timer programming is done
when the Recorder clock has not been
set.
• Occurs when empty space in the
disc runs out.
• Occurs when recording stops
before disc information has been
correctly written onto a DVD, due to
a problem like a power failure.
Suggested Solution
• Check the disc, and load it correctly.
• Cancel disc protection, or reload a
recordable disc.
• Check the disc, and load it correctly.
• Cannot record.
• Erase unnecessary titles.
• Either erase unnecessary chapters, or
combine chapters.
• Reload an appropriate recording
disc.
• Load a tape into the digital
camcorder.
• Check the disc, and load it correctly.
• Load a disc with empty space.
• Erase unnecessary titles.
• Load a CPRM compatible disc (DVD-
RW Ver. 1.1 or higher) initialised in VR
mode.
• Connect a digital camcorder, and
reset again to DV input.
• Set the clock and perform timer
programming again.
• Wait until DVD disc recovery is
finished.
Continued on Next Page |||
121
GB