Sharp DV-HR400S Operation Manual page 107

REC FUNCTION
ALTERNATIVE REC SET
• This function is for switching recording to HDD when you originally set to record to
DVD-RW/R but could not because of the disc situation. This function works in the
following cases.
* 1 When there is not enough disc capacity left in DVD.
2 When an unrecordable disc is loaded.
3 When you forget to load a disc.
4 When a disc is playing within 2 minutes prior to the start of timer recording.
* In case 1, when the remaining capacity of HDD is less than that of DVD, the
recording will continue on to DVD.
DVD AUTO INITIALISE
• This sets the Recorder so it automatically initialises any unused DVD-RW discs which
are loaded into the Recorder.
You can initialise in either VR mode or Video mode.
EXACT REC. SETTING
• This function works when timer recording (GUIDE Plus+/Timer Programme) onto DVD-
RW/R. If disc capacity runs low, and the programme cannot be recorded to the end,
this function will automatically change the recording mode so the programme will fit.
(The recording mode set in above situation will have lower picture quality than the
originally set recording mode.)
• If there is very little disc capacity left on the disc, the programme may not fit even if
Exact Recording is set.
• When recording in EP or MN1 mode, there is no lower recording mode, so Exact
Recording will not work.
(ALTERNATIVE REC SETTING)
(DVD AUTO INITIALISING SETTING)
(EXACT RECORDING SETTING)
Function Setting
YES
NO
VR MODE
VIDEO MODE
YES
NO
105
GB