Playing 2 Channel Audio With A Digital Connection - Sharp DV-HR400H Operation Manual

Playing 2 Channel Audio with a
Digital Connection
The Recorder
DIGITAL AUDIO Output
COAXIAL jack
To DIGITAL
AUDIO Output
COAXIAL jack
Coaxial digital cable
(commercially available)
To coaxial digital
input jack
Audio equipment with an
optical* or coaxial digital
input terminal
Important!
• When using this connection, set the applicable type of
signal (Dolby Digital or MPEG) in "DGTL AUDIO OUT
SET" to "PCM" (see page 112). For DTS, PCM is not
applicable.
Digital Connection to an MD Recorder to Record a CD
• Only audio equipment with a digital input terminal
compatible with a sampling frequency of 48kHz can
record digital audio of DVD, TV broadcast, etc. For
example, in the case of MD, only those with a built-in
sampling rate converter can do this.
• When you connect this Recorder to an MD recorder
to record an Audio CD onto an MD, set "Dolby Virtual
Surround" as "OFF". If you set "Dolby Virtual
Surround" as "ON", track numbers will not be
recorded on the MD.
• When the internals between CD tracks is short or you
specify the CD track on the Function Control screen,
the track numbers of the CD may not match the track
numbers recorded to the MD.
To DIGITAL
AUDIO Output
OPTICAL terminal
Optical digital cable
or
(commercially available)
To optical digital
input terminal
* DV-HR480H only
Enjoying High Quality Sounds
Digital Connection to an MD Recorder or
Other Audio Equipment without a Dolby
Digital Decoder
Audio CD or Video CD
• You can enjoy these discs by playing them back by the
ordinary playback procedure. (The normal audio output is
not played back for discs recorded with DTS.)
DVD Video Disc
• There is no audio signal generated for DVD video discs
recorded with DTS. A processor or amplifier equipped
with a DTS Surround decoder function is required to enjoy
DTS audio.
99