Auto Installation; Turning The Power On; Using The Auto Installation For Initial Setting - Sharp DV-HR400H Operation Manual

Auto Installation

Turning the Power On

Press OPERATE on the remote
control or Recorder to turn on the
Recorder's power.
• When you turn on the Recorder's power,
the HDD and DVD mode indicators will
blink on the Front Panel Display. During the
blinking stage, system processing is in
progress. Wait until the blinking stops and
the HDD mode indicator turns on.
• When the Recorder power is turned on for the
first time after purchase, the "AUTO
INSTALLATION" screen is displayed. Follow
the procedure shown on pages 25, 26.
NOTE
Operating the power source while TV
listings data is being downloaded
• Even when the power is off, during
download of TV listings data, the internal
state of the power source is on. When you
want to use the Recorder while TV listings
data is being downloaded, press OPER-
ATE and the STANDBY indicator on the
Recorder will turn red. (It may take 1-2
minutes for the STANDBY indicator to turn
red.) After the STANDBY indicator has
turned red, press the OPERATE button
again. (The download of TV listings data
will be suspended.)
• When TV listings data is being down-
loaded, the Front Panel Display appears as
follows:
To Enter STANDBY
Press OPERATE on the remote
control or Recorder to enter
STANDBY.
• The HDD and DVD mode indicator will go
out, and the STANDBY indicator will turn
red.
• If you press OPERATE immediately after
entering STANDBY, the Recorder may not
turn on. If this happens, wait a short period
and then press OPERATE again.
About the Power Supply
• Do not unplug the power cord immedi-
ately after you plug it into the AC outlet
(less than about 15 seconds after
plugging in). In very rare cases, this
may cause the memory to revert to its
initial state, and all timer programmes
will be erased. If you pull out the power
plug while power is on, it will take a
while for the hard disc to get ready
when you turn on power the next time.
During this time you can only view live
broadcasts.
• If you turn on power in a low tempera-
ture environment, only live broadcast
viewing is possible until the hard disc
(HDD) reaches its operating tempera-
ture.
Using the AUTO
INSTALLATION
for Initial Setting
When the Recorder power is turned on for the
first time after purchase, the "AUTO
INSTALLATION" screen is displayed. You can
use the "AUTO INSTALLATION" function for
easy initial settings regarding TV channel and
time/date. From the second time on, the
"AUTO INSTALLATION" screen will not
appear.
Preparation
• Turn on the TV's power and switch to the
AV input you used to connect the Recorder.
1
Press OPERATE for the first time
after purchase.
AUTO INSTALLATION
AUTO INSTALLATION
BEFORE AUTO INSTALLATION STARTS.
CONFIRM THAT THE ANTENNA CABLE/SCART IS
CONNECTED TO THE UNIT AND THEN PRESS ENTER KEY.
ENTER
ENTER
ENTER
• The "AUTO INSTALLATION" screen is
displayed.
2
Ensure your Aerial cable or SCART
cable is connected to the Recorder,
then press SET/ENTER to confirm.
Continued on Next Page |||
2 [ SAT ]
4 2 1 / 1 : 0 8 2
25