Selecting The Original Size - Sharp AR-C262M Operation Manual

SELECTING THE ORIGINAL SIZE

When the correct original size is not detected or the original size is not displayed, you can manually specify the
original size.
By causing the machine to recognize the original size, you can have the automatic ratio selection function (page 5-
12) automatically set a suitable enlargement or reduction ratio for the selected paper size.
Place the original in the document feeder tray or on the document glass and then follow the steps below.
Touch the [ORIGINAL] key.
1
AUTO
ORIGINAL
AUTO
EXPOSURE
2 Enter the original size.
If the original size is a standard size, touch
the appropriate original size key.
OK
A5 A4
A5R A4R
AB
B5 B4 INCH
B5R A3
STANDARD SIZE
SIZE INPUT
If you wish to select an inch size, touch the
[AB/INCH] key and then touch the desired
original size key.
OK
1 /
5 1 / 8 1 / 8 X 13
X
2 2 2
1 / 1 /
5 X 8 R 8 1 / 14
X AB
2 2 2
8 1 / X 11 11 17
X INCH
2
8 1 / X 11R
2
STANDARD SIZE SIZE INPUT
If the original size is a non-standard size,
touch the [SIZE INPUT] tab and then enter
the X (width) and Y (length) dimensions of
the original with the
X
OK
Y
(64 432)
X 420
mm
(64 297)
Y 297
mm
STANDARD SIZE SIZE INPUT
Using the reversing
automatic
document feeder
X (horizontal 139 to 432 mm
direction) (5-1/2" to 17")
Y (vertical 100 to 297 mm
direction) (4" to 11-3/4")
4-8
[MANUAL] and the
original size key you
touched are highlighted.
[INCH] is highlighted
and AB size keys are
displayed. To return to
the AB palette, touch the
[AB/INCH] key once
again.
or key.
The X dimension (width)
is initially selected.
Touch the Y ( ) key
and enter the Y
dimension (length).
The range of original
sizes that can be
entered is as follows.
Using the
document glass
64 to 432 mm
(2-1/2" to 17")
64 to 297 mm
(2-1/2" to 11-3/4")
Touch the [OK] key.
3
You will return to the initial screen.
4 The selected original size appears in the
top half of the [ORIGINAL] key.
X160 Y280
ORIGINAL
AUTO
EXPOSURE