Timer Operation - Sharp Plasmacluster AE-A09DJ Operation Manual

TIMER OPERATION

TIMER OFF
The unit will turn off automatically according to your setting.
Timer duration can be set from minimum 0.5 hours (30 minutes) to maximum 12
hours.
Up to 9.5 hours, you can set by 0.5 hours (30 minutes) increments and from 10 to 12
hours, by 1 hour increment.
MODE TEMP.
FAN TIMER
TEMP.
DISPLAY MODE
1h FAN
SWING CANCEL
Example : When you wish to stop the operation
2.5 hours later.
TIPS ABOUT TIMER OFF OPERATION
When the TIMER OFF is set, the temperature
setting is automatically adjusted to prevent
the room from becoming excessively hot or
too cold while you sleep. (Auto Sleep function)
COOL/DRY MODE:
• One hour after the timer operation begins, the
temperature setting rises 1°C higher than the
original thermostat setting.
HEAT MODE:
• One hour after the timer operation begins, the
temperature setting drops 3°C lower than the
original thermostat setting.
NOTE:
• The Auto Sleep function will not activate during
the FAN ONLY mode.
Point the remote control at the signal receiver win-
dow on the unit.
1
Press the TIMER OFF (
time as desired.
• The time setting will change as you to press the
button as follows.
0.5h
Hold the button pressed down for fast setting.
• The orange TIMER lamp (
light.
1
• The unit will generate a beep when it receives the
signal.
• The time setting will count down to show remain-
ing time.
Press the CANCEL button.
• The orange
Press the TIMER button which you wish to
change, (TIMER OFF or TIMER ON) and
change the time setting.
12
1.0h 1.5h 10h
TO CANCEL TIMER
TIMER lamp
DISPLAY MODE
( ) on the
unit will turn
off.
TO CHANGE TIMER SETTING
) button and set
11h 12h
) on the unit will
1h FAN
SWING CANCEL