Basic Operation Of The Projector - Sharp XV-380H Operation Manual

Basic Operation of the Projector
1. Turn on the MAIN POWER.
Press the MAIN POWER
switch ON.
PAL SECAM
I I I 1
When the power is on, the LAMP
REPLACEMENT indicator flashes
to show the operating condition
of the lamp.
Green: Lamp is ready
Flashing green: Warming up
Red: Change bulb
On-Screen Display
I
Indicator off:
Main Power switch is set to off
Indicator lights red:
Standby status
Indicator lights green:
Projector lamp on
LAUQVAOI
,EIIOLISH sVwfsI[A
DIUTSCH
ITALIARO
SSQAIOL
rrnuqr1s
IIEDERLAl9DS E*ti
2. Turn on the POWER.
Press the POWER button on the projector.
l
When the power is turned off by pressing
the POWER (ON/
OFF)
button,
the POWER indicator will not turn off until the
fan has stopped running.
l
See page 20, "Lamp/Maintenance Indicators",
for details.
Notes:
l
When the POWER indicator is not lit, the remote control
cannot be
used to operate the projector.
l
If the power is turned on immediately after
it has been
turned off, it may take a short while before the lamp turns
on. (During this period the LAMP REPLACEMENT indicator
flashes.)
l
After the projector is unpacked and turned on for the first
time, a slight odour may be emitted from the exhaust fan.
This odour will disappear with use.
3. ON-SCREEN DISPLAY in 8 languages
The on-screen display is set to English at the factory.
The
language
for the unit's ON-SCREEN DISPLAY can be set to
English, German, Spanish, Dutch, Swedish, Italian, French or
Japanese.
l
Setting the ON-SCREEN DISPLAY
language
1)
2)
3)
4.
Press the
MENU button. The menu will appear on the
screen.
Press the ADJUSTMENT V/A buttons until the b mark is
set to "LANGUAGE".
Press the MENU button to display the language menu.
Press the ADJUSTMENT V/A buttons until the b mark
matches the language desired, and then press the MENU
button to set the language. The ON-SCREEN DISPLAY is
now programmed to display in the language chosen.
Changing the system mode
1
The video input system mode is set to AUTO at the factory,
but it can be changed to a different
mode.
1) Press the MENU button. The menu will appear on the
screen.
2) Press the ADJUSTMENT V/A buttons until the b mark is
set to "SYSTEM".
Press the MENU button to display the system menu.
3) Press the ADJUSTMENT V/A buttons until the b mark
matches the video system desired and then press the
MENU button to set the system
VIDEO1
VIDEO1
NTSC 3.58
*PAL
NTSC 4.43
l SECAM
Note:
l
In AUTO mode, "PAL", "SECAM",
"NTSC 4.43"
or "NTSC
3.58" is displayed on the screen for a few seconds when
the
mode is changed with the INPUT SELECT button.