Remote Control Operation; Inserting The Batteries - Sharp XV-380H Operation Manual

Remote Control Operation
REMOTE CONTROL
VOLUME UP-DOWN buttons
ADJUSTMENT (WA) buttons
(Can be used as ADJUSTMENT
(V/r) buttons when the MENU
button is pressed)
ADJUSTMENT (4/b) buttons
LENS ADJUSTMENT button
MENU button
LIGHT button
Using the remote control
a dark
room
Press the LIGHT button.
l
This will cause the operation
buttons to stay lit for about 5
seconds.
Press down -
c
Slide open
e
2s
-air
REMOTE CONTROL SIGNAL TRANSMITTER
I
I
ON/OFF
r MUTE
INPUT
SELECT
SHARP
LCD PROJECTOR
- TRANSMIT indicator
- POWER (ON/OFF) button
- MUTE button
- INPUT SELECT button
Remote
control handling
precautions
Do not expose the remote control
to shocks, liquids or high humidity.
The remote control may not
operate normally if exposed to
direct sunlight or other intense
light sources. Should this happen,
reposition the light source or the
LCD Projector.
Inserting the Batteries
Remove the battery cover as shown and insert two AAA size batteries making sure
the polarity matches the (+) and (-) marks inside the battery compartment.
Notes:
Incorrect use of batteries may cause them to leak or burst.
l
l
in
l
t
l
close
0
Batterjl cover
Insert the batteries with the (+) and (-) polarities as indicated.
Remove the batteries if the remote control will not be operated
for an extended
period of time.
Maintain the batteries in clean condition.
Do not mix different brands of batteries. The life expectancy of the new batteries
will be shortened and the old batteries may leak.
When the batteries have been used up, remove them immediately to prevent
leakage and damage. Leaked battery fluid may irritate the skin. Remove any
battery fluid by wiping with a cloth.
Due to storage conditions and the shelf life of the supplied batteries, they may
run out after a short time. Replace them with new batteries as soon as possible.
Use the remote control as shown in the figures on the left.
1
Max. distance: 7m