Basic Operation Of The Projector; Turn On The Main Power - Sharp XG-E3000U Operation Manual

Basic Operation of the Projector

1
A.C.120V
C.A.120V
ON
OFF
2
MAIN
POWER
switch
2
ON/OFF
ON
POWER
OFF
3 Projector
ON/OFF
ON/OFF
ON/OFF When the power is on, the LAMP
REPLACEMENT indicator flashes
to show the operating condition of
POWER
the lamp.
Green:
LAMP
Flashing green:
TEMP. Red:
E-23
1
AC cord
When the MAIN
POWER is on, the
POWER indicator
lights red.
LAMP
TEMP.
Remote control
ON/OFF
ON
OFF
Lamp is ready
Warming up
Change bulb
1. Connect the AC cord.
Connect the supplied AC cord to the AC inlet on the side
of the projector .

2. Turn on the MAIN POWER.

Press the MAIN POWER switch on the side of the projec-
tor. The POWER indicator lights red and the projector
enters STANDBY mode.
3. Turn on the POWER.
Press the POWER ON/OFF button on the projector or the
POWER ON button on the remote control.
When the power is turned off by pressing the POWER
ON/OFF button, the POWER indicator will not turn off
until the fan has stopped running.
See page 32, "Lamp/Maintenance Indicators" for
details.
Notes:
When the POWER indicator is not lit, the remote control cannot be
used to operate the projector.
If the power is turned on immediately after it has been turned off, it
may take a short while before the lamp turns on. (During this period
the LAMP REPLACEMENT indicator flashes.)
After the projector is unpacked and turned on for the first time, a slight
odor may be emitted from the exhaust fan. This odor will soon
disappear with use.