System Wiring; Jumper Setting - Scytek electronic Precision Blue Product Manual

8-Pin Main Harness
Pin 1 GREEN WIRE: negative lock output (-) 500mA.
Pin 2 BLUE WIRE:
Pin 3 ORANGE: Armed Output (-) 500mA. The ORANGE wire provides a ground output while armed to
activate an optional starter defeat relay or other device such as a power window control module.
Pin 4 BROWN/WHITE WIRE: Horn Output (-) 500mA. Connect to the vehicle's horn, this wire can be
programmed to become parking light output (-) 500mA.
Pin 5 BLACK WIRE: Ground Input (-). The BLACK wire must connect to a solid chassis ground. Clean away
any paint or dirt to insure the best possible ground.
Pin 6 Empty: N.A
Pin 7 YELLOW WIRE: +12V Ignition Input. The YELLOW wire must connect to a main ignition wire at the
ignition harness. This wire must show +12V when the ignition is on. This wire will trigger the horn
for 30 seconds when the system is armed.
Pin 8 RED: +12V Battery Input (15A Fuse). The RED wire must be connected to a clean source of
continuous +12V power.
Plug-in Connectors
2-Pin Red Connector: Plug-in connector port for LED. Mount the LED in an area where it may be easily
seen from either side of the vehicle.
2-Pin Blue Connector: Plug-in connector port for valet switch. Mount the valet switch in an area that is
easily accessible from the driver's position.
6-Pin Black Connector : Plug-in connector port for Bluetooth Antenna.
2- 3 Pin Blue Connectors : Cnet (network) connectors for optional Accessories.
Master/Slave Jumper
Jumper On = Master Mode. (stand alone mode)
Jumper Off= Slave mode.

System Wiring

negative Unlock output (-) 500mA.
( connected to other ScyTek products through Cnet port)
Precision Blue - Page 5